Straight Razor Technique

How to Shave with a Straight Razor

Step-by-step cut throat razor instructions: stropping, prep, lather, grip, angle, skin stretching, face order, aftercare, safety, and what to expect.

On this page
  1. Before You Start: What a Straight Razor Shave Involves
  2. What You Need
  3. Step 1: Strop the Razor
  4. Step 2: Prepare Your Skin and Beard
  5. Step 3: Build and Apply the Lather
  6. Step 4: Grip, Angle and Stretch
  7. Step 5: Work Through the Face in Order
  8. Step 6: Second Pass and Touch-Ups
  9. Step 7: Rinse, Treat Nicks and Moisturize
  10. Step 8: Clean, Dry and Store the Razor
  11. Troubleshooting Common Problems
  12. How Safe Is a Cut Throat Razor?
  13. Benefits of a Cut Throat Shave (and the Trade-Offs)
  14. Why Did Men Stop Using Straight Razors?
  15. How Long Does It Take to Learn?

Before You Start: What a Straight Razor Shave Involves

A straight razor, also called a cut throat or open razor, is a single folding blade that you sharpen and maintain yourself. Nothing guards the edge, so the closeness and comfort of the shave come down to your technique, not the razor’s design.

That has two practical consequences. First, a straight razor shave is slower than a cartridge or safety razor shave, especially while you’re learning. Plan on giving it unhurried time. Second, most of the skill lies in a few fundamentals: a sharp edge, good prep, a light grip, a shallow blade angle and taut skin. If you get those right, the rest follows with practice.

This guide covers the full routine. Deeper pages in this section go into the individual techniques: how to hold the razor, finding the right blade angle, and stretching the skin.

What You Need

A Shave-Ready Razor

The single most common reason first shaves go badly is a razor that isn’t sharp enough. Many new straight razors leave the factory with an edge that needs a proper hone before it shaves comfortably. “Shave-ready” means the razor has been honed and stropped to shaving sharpness, usually by the retailer or a professional honer.

If you’re buying your first razor, it’s worth paying for a shave-ready one or sending it to a honer before use. A dull razor tugs, and tugging tempts you to press harder. Pressing harder is how cuts and irritation happen.

For a first razor, many experienced shavers suggest:

  • Width around 5/8 inch. It’s a common, manageable size, wide enough to hold some lather and narrow enough to get around the face.
  • A round point. A rounded tip is more forgiving than a square or spike point, which can catch the skin.
  • A moderate hollow grind. Very thin, full-hollow blades give a lot of feedback but can feel unforgiving to some beginners. A half- or full-hollow from a reputable maker is a reasonable start.

Carbon steel is traditional and is generally considered easier to hone, but it rusts if left wet. Stainless steel resists rust better. Either works if you look after it.

Straight Razor or Shavette?

A shavette looks like a straight razor but takes a replaceable blade, often a half of a double-edge blade. Shavettes need no honing or stropping, which makes them appealing, and they’re common in barbershops for hygiene reasons.

The catch is that many shavers find shavettes less forgiving than a traditional razor. The thin disposable blade is very sharp and flexes less predictably, so nicks can come more easily. A shavette is a valid way to learn the motions, but if it feels harsh, that isn’t necessarily a sign that straight razor shaving isn’t for you.

Strop, Lather and Aftercare

You’ll also want:

  • A strop. It’s typically a hanging leather strop, often with a linen or canvas side, used before each shave to refine and align the edge.
  • Shaving soap or cream and a brush. A dense, slick lather protects the skin and lets the blade glide.
  • A towel for a warm compress.
  • Something for nicks. An alum block or styptic pencil or powder.
  • An alcohol-free balm or moisturizer for afterwards.

Step 1: Strop the Razor

Stropping doesn’t sharpen a dull razor. It refines and straightens a sharp edge that has been honed already. Most straight razor users strop before each shave.

  1. Hold the strop taut. A sagging strop rounds the edge.
  2. Lay the razor flat on the strop with both the spine and the edge touching, edge pointing toward you.
  3. Draw the razor away from you, spine first, edge trailing. Never move the edge forward into the leather.
  4. At the end of the stroke, roll the razor over on its spine (not on its edge) and draw it back the other way.
  5. Use light pressure. The weight of the blade is roughly enough.

If your strop has a linen or canvas side, many shavers use that first, then the leather. Exact stroke counts vary by preference. A few dozen laps on leather is common. Go slowly while you’re learning: it’s easy to nick a strop or roll the edge with a fast, sloppy flip.

Step 2: Prepare Your Skin and Beard

Softened whiskers cut more easily, and a straight razor rewards good prep more than most razors do.

  • Shave after a warm shower, or wash your face with warm water and hold a warm, damp towel against it for a minute or two.
  • Wash off oils and grime. A clean face lathers better.
  • Optionally, apply a pre-shave oil or cream. Some people find it helps, others don’t. It isn’t essential.

Step 3: Build and Apply the Lather

Load your brush from the soap or cream, build a lather that looks glossy and holds soft peaks, then work it into your beard with circular or painting strokes. The brush helps lift the whiskers and spread the lather evenly.

Aim for lather that stays wet. If it dries before you reach an area, re-lather that area rather than shaving over a dry film. A good rule many barbers follow: don’t take a stroke on skin that isn’t lathered.

Step 4: Grip, Angle and Stretch

These three things work together and get their own guides, but here are the essentials.

Grip. Open the razor so the scales swing well past straight, back toward your wrist. In the common standard grip, your index and middle fingers rest on the back of the shank, your thumb sits on the underside of the shank near the blade, and your ring finger or little finger rests on the tang. Hold it firmly enough to control, loosely enough to stay relaxed. Our guide to straight razor grips covers the backhand and pinch grips you’ll use on harder areas.

Angle. Hold the blade at a shallow angle to the skin, commonly given as around 30 degrees. One practical way to find it is to lay the blade flat on your skin, then lift the spine slightly until the edge starts to cut. Too flat and the blade skates over the hair. Too steep and it scrapes or nicks. More on this in the right blade angle for straight razor shaving.

Stretch. Use your free hand to pull the skin flat and taut, so the edge meets a smooth surface instead of a fold. Keep your stretching fingers behind the blade, not in its path. Our skin stretching guide goes area by area.

Throughout: no pressure. Let the edge do the cutting. Move the razor in the direction the spine is pointing, roughly perpendicular to the edge. Never slide it sideways along the edge, which is how a razor cuts skin.

Step 5: Work Through the Face in Order

Shave in short, steady strokes and rinse or wipe the blade frequently. Most guides start with the flattest, easiest areas and leave the trickiest ones until you’re warmed up.

Sideburns and Cheeks

Start at the sideburn on your dominant-hand side. Stretch the skin upward from the temple with your free hand, then take short downward strokes with the grain. Work forward across the cheek toward the mouth.

For the other cheek, you can switch the razor to your other hand or use a backhand grip. Both are fine. Many beginners start with only one side and finish the rest with their usual razor.

Jawline and Chin

The jawline curves, so shorten your strokes and adjust the angle to follow it. Many barbers advise starting a stroke slightly away from a prominent bone like the jaw or chin rather than directly on it. Then work over it with gentle, steady strokes.

For the chin, pull your lower lip over your teeth to flatten the area, and use shorter strokes. This is one of the most common spots for nicks, so take your time.

Upper Lip

Stretch the upper lip by pulling it down over your teeth, and push the tip of your nose up slightly with a finger of your free hand. Shave the two sides with short downward strokes. Many people shave the center under the nose separately with the toe of the blade. A pinch grip can help here.

Neck

Tilt your head back to stretch the neck. Neck hair often grows in several directions, sometimes swirling, so take a few seconds to map your grain before the shave. Run your fingers over the stubble: the direction where it feels smoothest is with the grain. On the first pass, shave with the grain wherever you can.

Be especially gentle around the Adam’s apple. Many people shave around it rather than over it, or press it lightly to one side with a finger.

Step 6: Second Pass and Touch-Ups

After the first pass, rinse with warm water and feel your face. If you want it closer, re-lather and do a second pass across the grain (at roughly a right angle to the first). Experienced shavers sometimes do a third pass against the grain. Many beginners stick with one careful pass, or one with the grain plus one across, for their first few weeks.

Against-the-grain shaving gives the closest result but is also more likely to cause irritation and ingrown hairs, particularly on the neck. It’s optional, not required for a good shave.

For stray hairs, re-lather the spot and touch it up. Avoid dry-shaving over bare skin to chase the last few whiskers.

Step 7: Rinse, Treat Nicks and Moisturize

Rinse off remaining lather with cool or lukewarm water and pat your face dry, rather than rubbing.

For small nicks, press an alum block or styptic onto the spot. Alum is mildly astringent and often stings a little. If it stings across your whole face, that can be a sign of irritation from too much pressure or too many passes.

Finish with an alcohol-free balm or moisturizer. Pat it in gently.

Step 8: Clean, Dry and Store the Razor

  • Rinse the blade, then dry it thoroughly, including the area near the pivot. Wipe from the spine toward the edge, never along the edge.
  • Let the razor air-dry open for a while before closing it, so moisture doesn’t stay trapped in the scales.
  • Store it somewhere dry, outside the steamy bathroom if possible.
  • For carbon steel razors stored for a while, a thin coat of oil (camellia oil is a traditional choice) helps prevent rust.

Even with regular stropping, the edge will eventually need re-honing. Many shavers find that’s somewhere in the range of every few months, depending on use, beard and technique. If the razor starts pulling despite good stropping, it’s probably time.

Troubleshooting Common Problems

Problem Likely causes What to try
Tugging or pulling Dull or not shave-ready edge, angle too flat, poor prep Strop carefully; have the razor professionally honed; improve prep
Razor burn Pressure, too many passes, angle too steep, against the grain too soon Lighter touch, fewer passes, stick with the grain
Frequent nicks Steep angle, loose skin, sideways movement, rushing Stretch more, lower the angle, slow down, short strokes
Missed patches Angle too flat, strokes too long on curves Shorter strokes, adjust angle over contours
Ingrown hairs on the neck Against-grain passes, very close shaving Shave with the grain only for a while

How Safe Is a Cut Throat Razor?

A straight razor is sharp and unguarded, so it demands more care than a cartridge or safety razor. Small nicks are common while learning. Serious cuts are uncommon among people who follow the basics, but caution is warranted. The habits that keep shaving safe:

  • Never move the blade sideways along its edge.
  • Keep your stretching fingers behind the blade.
  • Use no pressure, and keep the angle shallow.
  • If you drop the razor, let it fall. Don’t try to catch it.
  • Don’t shave when rushed, tired or distracted.
  • Close and store the razor safely, away from children.

Hygiene also matters. Don’t share razors, since shared blades can transmit bloodborne infections.

Benefits of a Cut Throat Shave (and the Trade-Offs)

People who enjoy straight razor shaving tend to mention:

  • A very close shave once the technique and edge are right.
  • One blade, no clogging. A single wide edge doesn’t trap hair the way a cartridge can, and some people prone to razor bumps find a single blade gentler.
  • Low ongoing cost and little waste. There are no cartridges to replace, although hones, strops and professional honing cost something.
  • Control and ritual. You set the angle and pressure, and many people simply enjoy the process.

The trade-offs are real: a learning curve, more time per shave, regular stropping, occasional honing, and a higher risk of nicks while learning. A straight razor isn’t automatically better than a good safety razor. It’s a different tool that some people prefer.

Why Did Men Stop Using Straight Razors?

Straight razors were the main way men shaved for a long time. The safety razor with disposable blades, popularized by King C. Gillette in the early 20th century, was quicker to learn and needed no honing. Its spread was helped by large-scale military issue around the First World War. Electric shavers took more market share from the mid-20th century. As more men shaved themselves at home, the daily barbershop straight razor shave declined.

Interest has since revived. Enthusiast communities, artisan makers and barbers offering traditional shaves have all grown, and straight razors remain widely available. If you’ve heard they were banned, see are cut throat razors outlawed?

How Long Does It Take to Learn?

It varies a lot. Many people find their shaves become comfortable after a few weeks of regular practice, and feel truly confident only after a couple of months. Early on, it’s sensible to shave the easy areas with the straight razor and finish with your usual razor, adding a new area as each one becomes comfortable.

For a practical progression, see our straight razor tips for beginners. For a condensed version of the whole routine, see how do you shave with a straight razor? If you’ve inherited an old razor and wonder whether to shave with it or sell it, are old cut-throat razors valuable? can help. Once you’re comfortable, you can also use the razor for shaping and lining up a beard.

Keep exploring

Guides from other topics

All topics →